Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 2)

Tapping the aluminum block Tapping the holes wasn't exactly rocket science. It was hard to keep the tap straight in the holes but we got both of them tapped in an hour or so. We did have to back out the tap about every 1/2 turn to keep it from getting plugged with shaving but it cut through very well. Now that we have the 2 holes tapped we need to test fit the EGR valve and fittings along with drilling two holes so we can bolt the EGR to the new adapter. Page Three

Email    Print    Add Comment

Related Articles

Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 1)   8-3-2004

Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 3)   8-3-2004

Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 4)   8-3-2004

Custom Fabrication of an EGR system for a Ford 300 inline 6 (Part 5)   8-3-2004

User Comments

Add Comment

No comments have been posted.